Felted Lantern Necklace



Download 54.1 Kb.
Date14.04.2018
Size54.1 Kb.
Felted Lantern Necklace

Glass Stone Color Key:

Blue – Peace
Green – Happiness
Yellow – Strength
Red – Love

Yarn – Patons Classic Wool (22 feet)


Hook – I or J recommended
Glass Accent Beads – your choice

Beginning (Row 1)


Wrap the tail end of the yarn clockwise around the first two fingers of your left hand one time making sure to leave 10 inches in the length of the tail. Insert hook under first strand, hook the back strand and draw it up. Holding the loop you just made in place, ch 1. Then make 3 sc in loop. Pull the tail end of yarn to draw the loop to a close
Row 2: (working in the round) 2 sc in each of the three sc from beginning row 1. (equals 6 sc)
Row 3: 2 sc in each of the 6 sc from row 2 (equals 12 sc)
Row 4: sc in each st around (equals 12 sc)
Row 5: *dec over next 2 sc* 6 times
*Now choose a glass stone and insert it inside your pouch
Finish pouch by continuing to dec over next two sts until the pouch is completely closed. It should have a nautilus or sea shell shape.

Neck Chain


Continuing with same yarn, chain a length long enough so that when held to the beginning of the chain, it slips easily over your head. (Remember that it will shrink when felted, so be sure to allow a few extra inches.) Then join with a sl st to the top of the pouch. Be sure there is no twist in your chain. Finish off and weave in end securely.



Accent Beads
Using a large eye needle, thread the tail strand of yarn first through a larger bead, then through a smaller one. Thread the yarn back up through the larger bead and use a sewing knot to secure it to the bottom of your pouch. Finish off by weaving in the remaining tail securely and cutting off any excess yarn.

Hand Felting

Fill a large bowl or a sink with water as hot as you can tolerate. Submerge your necklace until it is wet through and then use dish or hand soap and lather it up. At first the yarn will stretch, so be careful not to let the stone fall out. Rinse off the necklace by agitating it in the water. Continue to soap and rinse until your necklace becomes the size you desire. While it is wet, it can be molded and shaped to your liking. Check the neck chain to be sure it’s not getting too short. It can be stretched out some while it is still wet. Blot dry without creasing the fibers.



Machine Felting
Start with a tablespoon of laundry soap, your lowest water setting and a hot wash cycle. About five minutes after agitation begins, check the status of your item. It will actually have gotten larger, as it will have relaxed in the heat of the water. This is perfectly normal. Back into the wash for another 5-10 minutes and you can then stop the agitation and see how it's coming along. Now is when you can pull it back into shape if it's twisted, or you can separate pieces that are sticking together and shouldn't be. Keep checking at 5-10 minute intervals until you have reached the desired size, which may take multiple wash cycles [do not run the entire machine cycle, but just rerun the wash portion]. Once it starts to felt down, it can shrink up pretty fast. You should start checking it more frequently to be on the safe side. If your item is resisting felting or stops shrinking before you'd like it to, remove it from the washer, wring it out, and a quick plunge into an ice water bath and back into the tub will work wonders. Adding a pair of old jeans or a pillow case for added agitation helps speed the process along. Never use a towel or your felted item will lint. It is very important to remove your item before the machine begins to drain and especially before the spin cycle. If left to spin, the felt can crease and those creases will never come out. Rinse off in a sink to remove excess soap. Lay flat on a towel to dry or block pieces like hats over an appropriately sized bowl.



Share with your friends:


The database is protected by copyright ©dentisty.org 2019
send message

    Main page